SPYDER MODEL 5 ENGINEERING TOOL – USER GUIDE
35 31-00282ES-01
6. Click OK to confirm.
RESULT: All devices are added to the database. The following properties are shown:
o Name
o Device ID
o Status e.g. Alarm, unacknowledged alarm.
o Model
o Firmware Revision
o Serial No.
o Irm Family
o Irm Program Name
o Irm Application Type
o Irm Sync Status synchronized or not synchronized
o Irm Last Change
o Irm Master Sync shows whether the device is part of a master sync group (source, target, none)
A synchronicity check is performed and particular messages are displayed if non-synchronicity is detected (see section
“Synchronicity Check via Control Manager”, p. 35).
Synchronicity Check via Control Manager
Whenever you connect to the BACnet network via device discovery (online mode) or when matching an empty IRM device
(offline mode) to a discovered device of the BACnet network, the control manager starts working and checks the
applications in the project and in the controller on synchronicity.
Example: Message when discovering device on the network
To Next Page
Loading...
