Honeywell ST 700 - HART DD binary file format compatibility matrix for ST 700 Standard Transmitter

Page 96 ST 700 Series HART/DE Option User’s Manual Revision 4.0
11.6 Basic Setup Page
11.6.1 Pressure Transfer Fn:
Allows for selecting the Transfer function; Linear or Square Root.
11.6.2 Low Flow Cutoff Mode:
Allows for selecting the User Config Mode and entering the Low Flow Cutoff breakpoint from 0-25%
to get the needed signal conditioning. Refer to Table 12 for more details
11.6.3 Device Information
Allows access to both read-only parameters and read/write parameters.
Provides access to Message, Clear Message and Maint Mode.
Transmitter Messaging