Basic configuration 47
BASIC CONFIGURATION
5. Enable Daylight Savings if required.
6. If Daylight saving is enabled, set the start and end date schedules for daylight savings.
7. Tap the back button to navigate back to the previous screen.
To enable screen cleaning mode
Screen cleaning mode lock/disable the touch sensitivity of the display for 30
seconds so you clean the device display while the thermostat is functional.
1. Swipe left from the Home screen.
2. On the Quick access screen, tap > Basic > scroll down > Screen Cleaning.
The Screen Cleaning screen appears.
Figure 23 Screen cleaning
3. Tap OK to enable the screen cleaning mode for 30 seconds or tap the back button to
navigate back to the previous screen.
To configure override setting
This is to allow the user to configure the override settings. There are two types of
override settings available.
Permanent Override - This provides schedule for 24/7 fixed setpoint control (No
occupied, standby periods).
Temporary Override - This allows authorized user to adjust setpoint or operating
mode for fixed interval that deviates from standard schedule.
The override occurs when the user manually changes the setpoint on the thermostat
screen. This overcomes the current mode from Occupied/Unoccupied/Standby to
temporary mode.
1. Swipe left from the Home screen.
2. On the Quick access screen, tap > Basic > scroll down > Override Setting.
The Override Setting screen appears.
To Next Page
Loading...
Need help?
General
