60 Configuring sensors
4 - CONFIGURATION
Figure 39 Sensors screen
4. Tap the required sensor, relevant sub menu appears to select the settings.
Note: The desire option may be “grayed-out” whenever there are insufficient outputs to support this function.
Verify I/O is configured appropriately.
To configure Sylk sensors
Make sure that the required Sylk devices are connected to the thermostat.
1. Swipe left from the Home screen.
2. On the Quick access screen, tap > Equipment > Sensor Settings > Sylk Sensors.
A list of Sylk devices appear with the respective bus address corresponding to the
address number listed in the thermostat listing.
To Next Page
Loading...
