Configuring sensors 61
CONFIGURING SENSORS
Figure 40 Sylk devices
Note: The total number of Sylk Devices is restricted by Power and Communication bandwidth. In general, the
number of Sylk devices cannot exceed the allowed limit. Contact the Honeywell Technical Support team
for additional support.
3. Tap the right arrow in the menu option to view the dip switch bus address setting guide.
Table 22: Sylk device dip switches
Sylk
Address
Device Type Sensors DIP Switches
2 Sylk Temperature &
Humidity & CO2
sensor
TR40
TR40-H
TR40-CO2
TR40-H-
CO2
TR50-3N
TR50-3D
Note: Set the red colored switches to the position as
shown in the above image
3 Sylk Temperature
sensor
TR40
4 Sylk Temperature
sensor
TR40
5 Sylk Temperature
sensor
TR40
To Next Page
Loading...
Need help?
General
