EasyManuals Logo

Honeywell Vocollect A700 Series User Manual

Honeywell Vocollect A700 Series
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
1. Remove the device from the belt clip.
2. Disconnect any wired peripherals.
3. Insert the device into an open slot on the charger, ensuring that the battery
contact side of the device is placed against the battery contact side of the
slot.
4. After the device has been placed into the charger, make sure that the device
state indicator on the device turns on a solid yellow.
l If the indicator does not turn on after 30 seconds, remove the device
from the charger slot and then place it into the slot again.
l If the indicator still does not turn on, try another charger slot.
Charging an A700x Device Battery
NOTE
l A battery is fully charged and can be removed from the charger when
the ring LED indicator light for that port on the charger is green.
l If you insert a fully charged battery into a charger, the charger will
analyze the battery's status and indicate charge status immediately.
1. Make sure the battery charger is powered. To power on the charger, connect
the power supply to the charger and a power source. The LED indicator light
at the bottom right of the charger face panel should be solid green.
2. Power off the device.
3. Remove the battery from the device.
4. Hold the battery with the pins downward and facing away from you, and
push it onto an empty port on the battery charger until it snaps into place.
5. When the ring LED indicator turns a solid green, the battery is fully charged.
Pull the battery off the charger port to insert it into the device.
Inserting a Battery into a Talkman A700/A700x
Device
Make sure the battery to be inserted is fully charged.
1. Hold the Talkman so that the battery compartment is facing up.
2. Hold the battery with the rounded side up.
3. Place the battery in at an angle, pins end first.
4. Push the back of the battery into place.
You will hear a click when the battery is in place.
CAUTION
Do not force the battery into the compartment. You may damage the
battery or the device. If the battery does not snap easily into place,
reposition the battery in the compartment and try again.
A700x Product Guide 12

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Vocollect A700 Series and is the answer not in the manual?

Honeywell Vocollect A700 Series Specifications

General IconGeneral
BrandHoneywell
ModelVocollect A700 Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals