hold the two devices steadily against each other.
6. Watch the device state LED indicator ring on the receiving device to confirm
configuration success or failure.
Successful configuration transfer: The receiving device LED indicator ring
blinks green for about two seconds, then the indicator signals the device
reboot process (flashes red briefly, then rotates yellow around the ring, then
rotates red).
Unsuccessful configuration transfer: indicator ring blinks red for about two
seconds, then returns to receiver mode
7. Repeat steps 5 and 6 for any remaining unconfigured devices.
Turning On an A700
Before you turn on a device, make sure a headset and charged battery are
properly connected to it.
1. Press the Play/Pause button on the device. Observe the LED on the device.
The LED ring is yellow and rotates, then the ring segment turns solid green.
2. The device says, "Current operator is operator name. Please keep quiet for a
few seconds." The device then starts a noise sample.
3. After a brief pause, it says, "Please wait." After another pause, the device
begins asking questions or providing instructions.
15 A700x Product Guide
To Next Page
Loading...
Need help?
General
