Using the Talkman Scanning Device Holster
A700x devices have two slots that run the length of the body. These can be used
to attach the device to a belt.
1. Put the belt on with the clip either on your right or left side.
2. Position the device so that the slots on the top and bottom align with the
runners on the clip.
3. Slide the device into the clip until you hear a click.
When you remove the device from the clip, you must apply a small amount of
pressure away from you while sliding it away from the clip.
CAUTION
The scanner is designed for occasional use and should not be used more
than six times per hour. Other scanning devices more suited to hands-free
and eyes-free scanning should be used for optimum performance.
Vehicle Mounts for Talkman A700
The Screw-on Mount is a mounting option that is bolted to a stationary surface
on a vehicle.
The Clamp Mount is a mounting option that is clamped to a stationary surface
on a vehicle. This can also be bolted to a stationary surface, if desired.
The Claw Mount is also clamped to a stationary surface, but can be clamped to
oddly-shaped or horizontal or vertical surfaces.
Screw-on Mount Clamp Mount
41 A700x Product Guide
To Next Page
Loading...
Need help?
General
