Network Indic-
ator
Network
State
What is Happening When This Occurs
Pulse
Connected to
network
Full network connection.
The device may be
requesting and receiving an
IP address.
TIP
If the LEDs indicate that there is a problem, refer to information on
troubleshooting to solve the problem. See also Troubleshooting Problems
Indicated by LED.
Loading an Operator's Templates on A700
You need a device with a charged battery, headset, and any other equipment
(belt, bar code reader) you are going to use. You must be within radio range.
Make sure the device is on or sleeping. The device should have a solid green
ring segment (on) or a rotating green ring (sleeping)
1. Press the Operator button.The device says "Current operator is operator
name. Select menu item."
2. Press the + button or — button until the device says, "Change operator."
3. Press the Operator button.
4. The device says, "Please wait" and retrieves a list of operators and teams.
Wait for the device to say, "Select team".
l If the device says "Current operator is (operator name). Change
operator", skip to step 8.
5. Press the + button or — button to scroll through the list of operator teams
until you hear the name of a team to which you belong.
6. Press the operator button.
The device says, "Please wait" and retrieves a list of all operators who belong
to the team that was selected. The device then says, "Current operator is
(operator name). Select new operator."
7. Press the + button or — button to scroll through the list of available operator
names until you hear your name.
l If you do not hear your name, press the yellow play/pause button to
cancel this operation and start over from step 2.
l When selecting a team in step 5, choose the "All Operators" team.
l Consult with your supervisor if you are not listed in the "All Operators"
team.
8. Press the operator button.
The device says, "Loading operator" and loads your templates. Once it has
loaded your templates, the device says, "Current operator is (your operator
23 A700x Product Guide