Honeywell XENON 1900 User Manual

94 Xenon/Granit User Guide
Number of Beeps - Base Error
The number of beeps and LED flashes emitted by the base for an error condition
can be programmed from 1 - 9. For example, if you program this option to have five
error beeps, there will be five error beeps and five LED flashes in response to an
error. To change the number of error beeps, scan the bar code below and then scan
a digit (1-9) from the Programming Chart, beginning on page 353, then Save.
Default = 1.
Scanner Report
Scan the bar code below to generate a report for the connected scanner. The report
indicates the port, scanner name, and address. To assign a name to your scanner,
refer to Menu Command Syntax,page 267.
Scanner Address
Scan the bar code below to determine the address of the scanner you are using.
Base Address
Scan the bar code below to determine the address of the base you are using.
Number of Base Error Beeps/LED Flashes
Scanner Report
Scanner Address
Base Address

Honeywell XENON 1900 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Linear (1D) barcodes supported	-
Standard interfaces	USB, Keyboard wedge, RS-232, RS-485
Connectivity technology	Wired
Input voltage	4 - 5.5 V
Power consumption	450 mA
Power source type	DC
Power consumption (standby)	0.45 W
Power consumption (typical)	2.3 W
Shockproof	Yes
Product color	Black
International Protection (IP) code	IP41
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Sustainability certificates	RoHS

Weight and Dimensions

Depth	104 mm
Width	71 mm
Height	160 mm
Weight	147 g