Honeywell XENON 1900 User Manual

Xenon/Granit User Guide 145
Good Read Tone - Output Sequences
Note: Partial sequence programming is only supported by Granit 1910i and Granit 1911i
scanners.
The scanner may be programmed to either beep or click in response to a good read
of each bar code in an output sequence, or to emit a beep or error tone for a partial
sequence. Default = Good Read Click - Each Code in Sequence and Error Tone - Par-
tial Sequence Output.
,
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple sym-
bols with a single pull of the scanner’s trigger. If you press and hold the trigger,
aiming the scanner at a series of symbols, it reads unique symbols once, beeping
Required
On/Not Required
*Off
Good Read Beep - Each
Code in Sequence
* Good Read Click - Each
Code in Sequence
Good Read Beep - Partial
Sequence Output
* Error Tone - Partial
Sequence Output

Honeywell XENON 1900 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Linear (1D) barcodes supported	-
Standard interfaces	USB, Keyboard wedge, RS-232, RS-485
Connectivity technology	Wired
Input voltage	4 - 5.5 V
Power consumption	450 mA
Power source type	DC
Power consumption (standby)	0.45 W
Power consumption (typical)	2.3 W
Shockproof	Yes
Product color	Black
International Protection (IP) code	IP41
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Sustainability certificates	RoHS

Weight and Dimensions

Depth	104 mm
Width	71 mm
Height	160 mm
Weight	147 g