Honeywell XENON 1900 User Manual

Xenon/Granit User Guide 63
Batch Mode Beep
When scanning in Inventory Batch Mode (page 62), the scanner beeps every time a
bar code is scanned. If using a Granit scanner, it also vibrates. When Batch Mode
Beep is On, you will also hear a click when each bar code is sent to the host. If you
do not want to hear these clicks, scan Batch Mode Beep Off. Default = Batch Mode
Beep On.
Batch Mode Storage
When a scanner is storing data during a Batch Mode process, you can select
whether the data is stored in Flash memory or in RAM.
Flash Storage: The scanner writes any untransmitted data to flash memory prior to
powering down. The data will still be there when the scanner powers back up. How-
ever, the scanner will power down, even with untransmitted data, if it reaches a
power down timeout or if the battery power is very low.
RAM Storage: The scanner will not power down while it contains data that has not
been transmitted to the base or Access Point, even if it reaches a power down time-
out. However, if the scanner runs out of battery power, it will power down and the
data will be lost.
Default = Flash Storage.
Batch Mode Beep Off
* Batch Mode Beep On
* Flash Storage
RAM Storage

Honeywell XENON 1900 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Linear (1D) barcodes supported	-
Standard interfaces	USB, Keyboard wedge, RS-232, RS-485
Connectivity technology	Wired
Input voltage	4 - 5.5 V
Power consumption	450 mA
Power source type	DC
Power consumption (standby)	0.45 W
Power consumption (typical)	2.3 W
Shockproof	Yes
Product color	Black
International Protection (IP) code	IP41
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Sustainability certificates	RoHS

Weight and Dimensions

Depth	104 mm
Width	71 mm
Height	160 mm
Weight	147 g