Honeywell XENON 1900 User Manual

CHAPTER
15
Xenon/Granit User Guide 331
MAINTENANCE AND
TROUBLESHOOTING
Repairs
Repairs and/or upgrades are not to be performed on this product. These services
are to be performed only by an authorized service center (see Customer Support on
page xvii).
Maintenance
Your device provides reliable and efficient operation with a minimum of care.
Although specific maintenance is not required, the following periodic checks
ensure dependable operation:
Clean the Scanner
The scanner or base’s housing may be cleaned with a soft cloth or tissue damp-
ened with water (or a mild detergent-water solution.) If a detergent solution is used,
rinse with a clean tissue dampened with water only.
Clean the Window
Reading performance may degrade if the scanner’s window is not clean. If the win-
dow is visibly dirty, or if the scanner isn’t operating well, clean the window with one
of the cleaning solutions listed for Health Care Housing, below.
Caution: Do not submerge the scanner in water. The scanner’s housing is
not watertight. Do not use abrasive wipes or tissues on the
scanner’s window. Abrasive wipes may scratch the window.
Never use solvents (e.g., acetone) on the housing or window.
Solvents may damage the finish or the window.

Honeywell XENON 1900 Specifications

General

Type	Handheld bar code reader
Sensor type	Laser
Scanner type	1D/2D
Pitch reading angle	-45 - 45 °
Linear (1D) barcodes supported	-
Standard interfaces	USB, Keyboard wedge, RS-232, RS-485
Connectivity technology	Wired
Input voltage	4 - 5.5 V
Power consumption	450 mA
Power source type	DC
Power consumption (standby)	0.45 W
Power consumption (typical)	2.3 W
Shockproof	Yes
Product color	Black
International Protection (IP) code	IP41
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Sustainability certificates	RoHS

Weight and Dimensions

Depth	104 mm
Width	71 mm
Height	160 mm
Weight	147 g