ALPHABETIC REFERENCE XI581/2 BUSWIDE OPERATOR INTERFACE
EN2B-0126 (74-3554-8) 62
Edit DIO Module Assignment
Address: 04
Unassign ▲
▲▲
▲
! XFL523 0001FC234088 1
XFL523 0001FC334056 ■
* XFL523 0001FC234062 ▼
Special characters indicate the module status according to the following key:
! An exclamation mark indicates that the module was previously assigned to this
controller in CARE but is now being used by another controller.
* An asterisk indicates that the module is being used by another controller. It is
displayed because module type and address match.
A blank indicates that this module is free and can be used for assignment.
7. Select a module by using the arrow keys to move to and highlight it and then
pressing Enter (↵).
RESULT: The assignment is accepted and the first 'Distributed I/O Module
Assignment' screen is displayed again.
DIO Module Assignment
02 ? XLF521 0001FC234088 ▲
▲▲
▲
03 <Unassigned> 1
04 - XFL522 0001FC234088 ■
■■
■
05 XFL524 0001FC234062 ▼
Another method to select a module is to press its LONWORKS service pin while the
result of step 6 is displayed.
RESULT: If the L
ONWORKS service pin is pushed, the following screen is
displayed:
Edit DIO Module Assignment
Module : 04 XFL523
Neuron ID: 0001FC234088
ASSIGN
8. Assign is highlighted by default. Press Enter (↵) to accept the assignment or
press Cancel (C) to return to the previous screen.
RESULT: If the assignment is accepted, the first 'Distributed I/O Module
Assignment' screen is displayed again.
Edit DIO Module Assignment
02 ! XFLF521 0001FC234056 ▲
▲▲
▲
04 ? XFL523 0001FC234088 1
05 XFL522 <Unassigned> ■
08 XFL524/29 IP-Bus Board ▼
IMPORTANT
After making any changes to the Distributed I/O module assignments, the
application must be saved to Flash memory so that the application will start
with the same module assignment after any kind of restart.
To Next Page
Loading...
