XI581/2 BUSWIDE OPERATOR INTERFACE ALPHABETIC REFERENCE
95 EN2B-0126 (74-3554-8)
Totalizers
Service Interval
All Totalizers
Service Interval Displays a list of digital points and the number of hours each
has operated.
All Totalizers Displays a list of totalizer points and the value for the units
assigned to the points.
Select Totalizer Type 2. Use the arrow keys to move to and highlight the type of totalizer you want to
reset. Then press Enter (↵) to complete the selection.
RESULT: The display window lists totalizer points. The following example
shows the service interval display window.
Service Interval h
Supply fan 1267 ▲
▲▲
▲
Exhaust fan 1257 ■
Burner 476 1
Htg. zone pump 736 ■
Cafe. hood 123 ▼
NOTES:
1. All totalizer points may not be able to appear in the display window at the
same time. To view totalizers that do not display, press the right arrow key to
display the next page.
2. The appearance of the 'All Totalizer' screen differs slightly from that of the
'Service interval' screen, although they operate the same.
Select a Totalizer 3. Use the arrow keys to move to and highlight the specific totalizer you want to
reset. Then press Enter (↵) to complete the selection.
NOTE: Additional user-defined text for the point may appear on the second
line.
RESULT: The display window shows detailed information about the selected
totalizer.
Service Interval : 1000 h
Supply fan : 1267 h
Reset : Yes/NO
Back
Service interval Number of hours a point can run before the controller
generates a maintenance alarm.
Supply fan Number of hours the point has run since it was last serviced.
The name of this field (Supply fan) is the user address of the
totalizer point you selected.
Reset Zero the totalizer point after service.
4. Reset the totalizer or define the service interval as follows:
Table 10. Resetting the Totalizer / Defining the Service Interval
To Next Page
Loading...
