UV-Scan
8 #03592DE-EN c
2. Safety notes
2.1. General notes
Knowledge of all basic safety regulations is essential to ensure safe han-
dling and fault-free operation of the unit. These operating instructions con-
tain the most important notes for operating the unit in a safe manner.
The operating instructions, especially the safety notes, must be observed
by everyone that works with the unit. In addition, all rules and regulations
on accident prevention that apply to the usage area must also be observed.
The operator must check at regular intervals that the staff are working with
a safety-conscious attitude.
Under workplace health and safety regulations, operators are required to
carry out a suitable and sufficient assessment of the risks arising from the
use of the unit.
The assessment must ensure that adequate control measurements are
maintained in order to eliminate or minimise these risks. You can use the
information contained in these operating instructions when making the risk
assessment.
2.2. Obligation of personnel
Persons who are assigned the task of working on and with the unit under-
take to do the following before starting work:
To observe the occupational safety and accident prevention regulations.
To read the chapter on safety and the warnings printed in this manual
and to observe them at all times while using the equipment.
The operator is responsible for compliance with all applicable to the perma-
nent establishment rules and standards.
2.3. Use in accordance with the intended purpose
Another or additional use of the device, as they explained in the descrip-
tion, is considered to be improper and dangerous.
The operator may only operate the unit in compliance with all the provisions
of these Operating Instructions.
The use of the UV-Scan in the area of medical technology, for monitoring
medical and therapeutic irradiation devices and to measure workplaces ac-
cording to the Guidelines of the Professional Trade Association on the
Avoidance of Dangers to Health from UV Radiation is not permitted.
Use for the intended purpose also includes:
Observance of all notes in these operating instructions.
Compliance with all general and specific safety instructions in these
operating istructions.
The execution of all servicing and maintenance work.
Compliance with the relevant accident prevention regulations.
To Next Page
Loading...