Example
Accessing
the
Logic
Analyzer
File
System
To
access
the
file
system
via
ftp
To
access
the file system via ftp
To access
the
logic
analyzer's file system using ftp,
enter
the
following
command on your computer:
ftp
[symbolic
namelIP
address)
The symbolic name is
the
host name of the logic analyzer as
set
up by your
system administrator. Typically, this name is found in
the
hosts
file
on your
computer or returned by a name server. It is equivalent to
the
analyzer's IP
(Internet Protocol) address.
When
the
connection is made, you will be prompted for a login name.
Enter
"control" or "data" depending
on
the
type of access you want.
If
you
are
prompted for a password, just press the Return or
Enter
key.
There is
no
password protection built into
HP
logic analyzers.
Using
ftp
To access
the
file
system of
the
logic analyzer named 1670sys using ftp enter:
ftp
1670sys
login
name:
data
ftp>
The exact commands you use
within
ftp depend on
the
software.
If
you
are
not
familiar with your ftp software, type
"?"
or "help"
at
the
ftp prompt to see
a list of commands.
2-8
To Next Page
Loading...
Need help?
General
