HP 1670A Series - Table of Contents

Contents
1 Connecting and Configuring
To connect to your network 1-3
To configure the network addresses 1-4
To verify connectivity with the ping utility 1- 7
To mount the logic analyzer 1-8
2 Accessing the Logic Analyzer File System
To mount the file system via NFS 2-3
To access the file system via ftp 2-8
3 Using the X Window Interface
To start the interface 3-3
To close the interface 3-8
To load the custom fonts 3-10
Additional Information 3-12
4 Retrieving and Restoring Data
To copy ASCII measurement data 4-3
To copy raw measurement data 4-5
To restore raw measurement data 4-6
To strip LIF structure from raw measurement data 4- 7
To copy screen images from \systern\graphics 4-9
To copy status information from \status 4-10
To copy configurations from setup. raw 4-12
To restore configurations 4-13
5 Programming the Logic Analyzer
To set up for Ethernet LAN programming 5-4
To enter corrunands directly using telnet 5-5
To copy corrunands to \systern\prograrn 5-7
To write programs that open \systern\prograrn 5-9
To write programs that open the corrunand parser socket 5-12
1