HP 240R G9

Table 5-8 Touchpad click board and touchpad part descriptions and part numbers
Description Spare part number
Touchpad click board L24486-001
Touchpad L24484-001
Touchpad board cable L23184-001
Touchpad click board cable L24485-001
Before removing the touchpad click board and touchpad, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 30).
2. Remove the rubber feet (see Rubber feet on page 30).
3. Remove the bottom cover (see Bottom cover on page 31).
4. Remove the battery (see Battery on page 32).
To remove the touchpad click board and touchpad:
1. Disconnect the touchpad cable (1) from the system board.
2. Disconnect the touchpad clock board cable (2) from the touchpad.
3. Remove the two Phillips M2.0 × 2.0 screws (3) that secure the touchpad click board to the computer.
4. Remove the board (4) from the computer.
NOTE: The edge of the board sits under clips. Be sure to slide the board out from under the clips
to prevent damage to the board or clips.
Touchpad click board and touchpad
39