HP 3000 Series Handbook

Error Code
Hex( Dec)
8E(142)
8F(143)
91(145)
thru
C0(192)
C1(193)
C2(194)
C3(195)
C4(196)
thru
C8(200)
C9(201)
CA(202)
CB(203)
CC(204)
thru
D0(208)
D1(209)
D2(210)
D3(211)
D4(212)
thru
D8(216)
For HP Internal Use Only
Table 5-50. DERROR Status
Codes (continued)
Description
DSP reset detected.
Minimum spindle speed could
not be maintained.
Tracking failure after a successful settle to a new setpoint.
Reserved.
PLL came unlocked in Slow Acceleration Phase.
Seek timed out in Slow Acceleration Phase.
Velocity
too high in Slow Acceleration Phase.
Unassigned seek fault in
Slow Acceleration Phase.
PLL came unlocked in
Fast Acceleration Phase.
Seek timed out in Fast Acceleration Phase.
Velocity too high in Fast Acceleration Phase.
Unassigned seek fault in Fast Acceleration Phase.
PLL came unlocked in the Coasting Phase.
Seek timed out in the Coasting Phase.
Velocity
too high in the Coasting Phase.
Unassigned seek fault in
the Coasting Phase.
Troubleshooting 5-57

HP 3000 Series Specifications

General

Brand	HP
Model	3000 Series
Category	Desktop
Language	English