HP 3000 Series Handbook

Error Code
Hex( Dec)
3B(59)
3C(60)
3D(61)
3E(62)
3F(63)
40(64)
41(65)
42(66)
43(67)
44(68)
45(69)
46(70)
47(71)
48(72)
49(73)
4A(74)
4B(75)
4C(76)
4D(77)
4E(78)
4F(79)
thru
7F(127)
80(128)
81(129)
82(130)
83(131)
84(132)
85(133)
86(134)
87(135)
88(136)
89(137)
8A(138)
8B(139)
8C(140)
8D(141)
For HP Internal Use Only
Table 5-50.
DERROR Status Codes {continued)
Description
SPES gain not within acceptable level.
Reserved.
Reserved.
Write current unsafe.
That command requires a special test enable to be executed.
Unknown write fault.
Write during loss of servo timing sync.
Write during momentary spindle off-speed indication.
Write during momentary
actuator off-track indication.
Write during a seek operation.
Write after settle or tracking failure.
Write following aggressive settle.
Write following inhibit
DSP code 7 is not defined.
Write
was attempted while ESDI attention was asserted.
Write was
attempted while an illegal head was selected.
Write
was attempted while a recalibrate was in process.
Write
was attempted on a head that was in the head alignment critical state.
Write was
attempted while a head alignment was in process.
Write was
attempted after a fatal head alignment occurred.
Write was
attempted while spun down or after a recalibrate failure.
Reserved.
No failure detected.
Unsupported command.
Illegal command sequence.
Servo heartbeat time out.
Spindle stuck.
Spindle couldn't reach full speed.
Servo PLL didn't lock.
Index
pattern fault.
TMR2 Alignment failure.
Servo PLL came unlocked.
Bad
hard track number.
Settle failure.
Alignment
Band AGC voltage not within legal range.
Heroics invoked during spin up.
5-56 Troubleshooting

HP 3000 Series Specifications

General

Brand	HP
Model	3000 Series
Category	Desktop
Language	English