24
Setting the Interfaces
Setting Jitter Receive Interface
4 If Option A3L, A3V or A3N, Jitter Receiver, is fitted, an ADDITIONAL
RMS FILTER choice is provided. You may possibly require different
filters to be connected for peak to peak and RMS measurements. The
additional RMS filter choice allows you the choice of a 12 kHz (high
pass) HP filter for RMS measurement only. If 12 kHz HP is chosen
under FILTER, the additional RMS filter choice is not available.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
