45
Selecting Test Features
Setting Receive Structured Payload/Test Signal
Setting Receive Structured Payload/
Test Signal
Description Structured PDH Payload/Test Signal settings determine the SONET
payload or the PDH test signal to be tested. Structured payloads are only
available if Option UKJ structured PDH or Option 110, DS1, DS3, E1,
E3 structured PDH is fitted.
TIP: If you wish to set the HP 37717C transmitter and receiver to the same
Payload settings, choose .
Option
Differences
If Option 110 is fitted a 2M or DS1 PAYLOAD is available depending on
the SIGNAL selection on the Receiver MAIN SETTINGS page.
1 Choose the required Test Signal rate. If N X 64 kb/s (or Nx56 kb/s
Option 110) is chosen, see "Setting Receive N X 64 kb/s (N X 56 kb/s)
Structured Payload/Test Signal " page 50.
2 Choose the Framing pattern of the PAYLOAD.
If 2 Mb/s TEST SIGNAL is chosen, DROP 2 Mb/s is added to the menu.
If DS1 TEST SIGNAL (Option 110) is chosen, DROP DS1 is added to
the menu.
See "Dropping an External Payload/Test Signal " page 54.
3 Choose the test tributary within the structured payload under 34Mb,
8Mb, 2Mb, 64 kb/s (DS2, DS1, 56 kb/s for Option 110 instruments).
OTHER
STORED SETTINGS COUPLED
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
