Component -Identifier- ------Detailed Description------
Cage cage:3 Firmware is not current
cage Suggested Action 4
Check the drive cage firmware revision using the commands showcage and showcage -d
cageX. The showfirwaredb command indicates what the current firmware level should be for
the specific drive cage type.
NOTE: Use the upgradecage command to upgrade the firmware.
cli% showcage
Id Name LoopA Pos.A LoopB Pos.B Drives Temp RevA RevB Model FormFactor
0 cage0 1:0:1 0 0:0:1 0 16 13-22 402d 402d DCN1 SFF
1 cage1 1:0:1 0 0:0:1 4 16 13-22 402d 402d DCN2 SFF
cli% showcage -d cage2
Id Name LoopA Pos.A LoopB Pos.B Drives Temp RevA RevB Model FormFactor
2 cage2 1:0:1 3 0:0:1 2 16 14-22 402d 402d DCS2 SFF
-----------Cage detail info for cage2 ---------
Position: ---
Interface Board Info Card0 Card1
Firmware_status Old Old
Product_Rev 402d 402d
State(self,partner) OK,OK OK,OK
VendorID,ProductID HP,DCS2 HP,DCS2
Master_CPU Yes No
SAS_Addr 50050CC1177A50FE 50050CC117739CFE
Link_Speed(DP1,DP2) 6.0Gbps,6.0Gbps 6.0Gbps,6.0Gbps
.
.
.
cli% showfirmwaredb
Vendor Prod_rev Dev_Id Fw_status Cage_type Firmware_File
...
HP [402e] DCS2 Current DCS2 /opt/tpd/fw/cage/ebod/hp_e6ebd_canister_local_combined_v402e.gff
cert
• Displays Certificate issues
• Reports SSL certificates that have expired, will expire in less than 30 days, and certificates
that will not be valid until a future date
Format of Possible cert Exception Messages
cert -- "Certificate <DNSname> for Service:<servicename> will expire in <count> days"
cert -- "Certificate <DNSname> for Service:<servicename> expired on <date&time>"
cert -- "Certificate <DNSname> for Service:<servicename> not valid until <date&time>"
cert Example
cli% checkhealth -detail cert
Checking cert
Component -----Summary Description------ Qty
cert Certificates that have expired 1
Component -Identifier- -----------------------------Detailed Description----------------------------
cert -- Certificate example.com for Service:wsapi expired on Jul 20 22:36:26 2014 GMT
cert Suggested Action
Use the CLI showcert command to display the current SSL certificates. Use the CLI removecert
command to remove the expired SSL certificate and the CLI createcert command to create a
SSL certificate with a valid date range.
42 Troubleshooting
To Next Page
Loading...
