EasyManua.ls Logo

HP 3PAR StoreServ 7000 - Pd Example 4; Pd Suggested Action 4; Pd Example 5; Pd Suggested Action 5

HP 3PAR StoreServ 7000
75 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
pd Example 4
Component --Identifier-- -------Detailed Description----------
PD disk:3 Detailed State: old_firmware
pd Suggested Action 4
The identified drive does not have firmware that the storage system considers current. When a
drive is replaced, the servicemag operation should upgrade the drive's firmware. When drives
are installed or added to a system, the admithw command can perform the firmware upgrade.
Check the state of the drive using CLI commands such as showpd -s, showpd -i, and
showfirmwaredb.
cli% showpd -s 3
Id CagePos Type -State-- -Detailed_State- --SedState
3 0:3:0 FC degraded old_firmware fips_capable
------------------------------------------------------
1 total
cli% showpd -i 3
Id CagePos State ----Node_WWN---- --MFR-- ---Model--- -Serial- -FW_Rev- Protocol Media Type -----AdmissionTime-----
3 0:3:0 degraded 5000C50072531BF4 SEAGATE SLTN0450S5xnF010 S0L05GTE 3P00 SAS Magnetic 2015-05-19 20:51:17
PDT
-----------------------------------------------------------------------------------------------------------------------
1 total
cli% showfirmwaredb
Vendor Prod_rev Dev_Id Fw_status Cage_type
...
SEAGATE [3P01] SLTN0450S5xnF010 Current DCS1.DCS2.DCN1 /opt/tpd/fw/drive/Lightning_SAS_FIPS_3P01.lod
pd Example 5
Component --Identifier-- -------Detailed Description----------
PD -- Sparing Algorithm is not set
pd Suggested Action 5
Check the system’s Sparing Algorithm value using the CLI command showsys -param. The value
is normally set during the initial installation (OOTB). If it must be set later, use the command setsys
SparingAlgorithm; valid values are Default, Minimal, Maximal, and Custom. After setting the
parameter, use the admithw command to programmatically create and distribute the spare
chunklets.
cli% showsys -param
System parameters from configured settings
----Parameter----- --Value--
RawSpaceAlertFC : 0
RawSpaceAlertNL : 0
RawSpaceAlertSSD : 0
RemoteSyslog : 0
RemoteSyslogHost : 0.0.0.0
SparingAlgorithm : Unknown
pd Example 6
Component --Identifier-- -------Detailed Description----------
PD Disk:32 ST3400755FC PD for cage type DCS2 in cage position 2:0:0 is missing from the firmware database
Troubleshooting Storage System Components 57

Table of Contents

Other manuals for HP 3PAR StoreServ 7000

Related product manuals