TX Power uW 476 158 562 125 631
RX Power uW 98 15 1000 10 1258
port Example 2
Component -Summary Description- Qty
Port Missing SFPs 1
Component -Identifier- -Detailed Description--
Port port:0:3:1 SFP is missing
port Suggested Action 2
FC node-ports that normally contain SFPs will report an error if the SFP has been removed. The
condition can be checked using the showport -sfp command. In this example, the SFP in 1:1:1
has been removed from the adapter:
cli% showport -sfp
N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
0:1:1 OK HP-F 8.5 No No No Yes
0:1:2 OK HP-F 8.5 No No Yes Yes
1:1:1 - - - - - - -
1:1:2 OK HP-F 8.5 No No Yes Yes
port Example 3
cli% checkhealth -detail port
Checking port
Component -Summary Description- Qty
Port Offline ports 1
-----------------------------------
1 total 1
Component -Identifier- --Detailed Description--
Port port:0:1:2 is offline
-----------------------------------
1 total
port Suggested Action 3
Check the state of the port with showport. If a port is offline, it was deliberately put in that state
using the controlport offline command. Offline ports might be restored using controlport
rst.
cli% showport
N:S:P Mode State ----Node_WWN---- -Port_WWN/HW_Addr- Type Protocol Label Partner FailoverState
...
0:1:1 target ready 2FF70002AC00006E 20110002AC00006E host FC - 1:1:1 none
0:1:2 target offline 2FF70002AC00006E 20120002AC00006E free FC - 1:1:2 none
...
port Example 4
Component ------------Summary Description------------ Qty
Port Ports with mismatched mode and type 1
Component -Identifier- ------Detailed Description-------
Port port:2:0:3 Mismatched mode and type
Troubleshooting Storage System Components 61
To Next Page
Loading...
