Page 1-20
Selecting properties of the equation writer (EQW)
First, press the H button to activate the CALCULATOR MODES input
form. Within the CALCULATOR MODES input form, press the @@DISP@ soft
menu key to display the DISPLAY MODES input form. Press the down
arrow key,
˜, three times, to get to the EQW (Equation Writer) line. This
line shows two properties that can be modified. When these properties
are selected (checked) the following effects are activated:
Detailed instructions on the use of the equation editor (EQW) are
presented elsewhere in this manual.
For the example of the integral , presented above, selecting the
_Small Stack Disp in the EQW line of the DISPLAY MODES input form
produces the following display:
References
Additional references on the subjects covered in this Chapter can be found
in Chapter 1 and Appendix C of the calculator’s user’s guide.
_Small Changes font size to small while using the equation
editor
_Small Stack Disp Shows small font in the stack after using the equation
editor
∫
∞
−
0
dXe
X
SG49A.book Page 20 Friday, September 16, 2005 1:31 PM
To Next Page
Loading...
