HP 5334B - 6-10. ORDERING INFORMATION

6-5. REPLACEABLE PARTS
6-6. Table 6-2 is the list of replaceable parts, and is organized as follows:
a.
Electrical assemblies and their components
in alphanumeric order by reference designation.
b.
Chassis-mounted parts in alphanumeric order by reference designation.
c. Miscellaneous parts.
6-7. The information given for each part consists of the following:
a. Hewlett-Packard part number.
b. Part number check digit (CD).
c. Total quantity (QTY) used in the instrument.
d. Part description.
e.
' Five-digit code that represents a typical manufacturer.
f. Manufacturer's part number.
NOTE
The total quantity for each part used in an assembly is given only once at
the first appearance of the part number in the list.
6-8. ILLUSTRATED PARTS BREAKDOWN
6-9.
Most mechanical parts are identified in Figure 6-1. This figure is located at the end of the replaceable parts
table.
6-10. ORDERING INFORMATION
6-11. Within the USA, Hewlett-Packard can supply parts through a direct mail order system. Advantages of
using the system are:
a. Direct ordering and shipment from the HP Parts Center in Mountain View, California.
b.
No maximum or minimum on any mail order (there is a minimum order amount for parts ordered
through a local HP office when the orders require billing and invoicing).
c. Prepaid transportation (there is a small handling charge for each order).
d. No invoices
- to provide these advantages, a check or money order must accompany each order.
6-12. Mail order forms and specific ordering information is available through your local HP office. Addresses
and phone numbers are located at the back of this manual.
6-13. To order a part that is not listed in the replacement parts tables, include the instrument model number, in-
strument serial number, the description and function of the part, and the number of parts required.
HP 5334B - Service Manual
6-3