A-36
The Boot Console Interface
Restoring the Factory Default VME EEPROM Configuration
Restoring the Factory Default VME EEPROM
Configuration
The NV_SECTIONS command restores the non-volatile sections area of the
system EEPROM to the default factory settings.
To restore the factory default settings, enter the following command:
VME Menu: Enter command >nv_sections de all
CAUTION: All VME system configuration data maintained in this area of the EEPROM is
restored to the factory default setting. All user data contained in this area of the
EEPROM is ERASED.
CAUTION: Do not reset the system or interrupt the power during the update process. The update
requires approximately 6 minutes to complete.
To Next Page
Loading...
