68
Parameters
bridge-aggregation: Displays the load sharing criteria of the aggregation group corresponding to the
specified Layer 2 aggregate interface.
interface-number: Specifies an existing aggregate interface number.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display the default global link-aggregation load sharing criteria.
Link-Aggregation Load-Sharing Mode:
Layer 2 traffic: packet type-based sharing
Layer 3 traffic: packet type-based sharing
# Display the configured global link-aggregation load sharing criteria.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
# Display the default link-aggregation load sharing criteria of the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname>display link-aggregation load-sharing mode interface Bridge-Aggregation
10
Bridge-Aggregation10 Load-Sharing Mode:
Layer 2 traffic: packet type-based sharing
Layer 3 traffic: packet type-based sharing
# Display the configured link-aggregation load sharing criterion or criteria of the aggregation group
corresponding to Layer 2 aggregate interface Bridge-Aggregation 10.
<Sysname> display link-aggregation load-sharing mode interface bridge-aggregation 10
Bridge-Aggregation10 Load-Sharing Mode:
destination-mac address, source-mac address
Table 17 Command output
Link-Aggregation Load-Sharing
Mode
Global link-aggregation load sharing criteria.
By default, the link-aggregation load sharing criteria for Layer 2 traffic,
Layer 3 traffic, Layer 4 traffic, and MPLS traffic are displayed.
If you have configured the global link-aggregation load sharing
criteria, the configured ones are displayed.
To Next Page
Loading...
Need help?
General