67
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Example
# Display the local system ID.
<Sysname> display lacp system-id
Actor System ID: 0x8000, 0000-fc00-6504
Table 16 Command output
Actor System ID: 0x8000, 0000-
fc00-6504
Local system ID, which comprises the system LACP priority (0x8000 in
this sample output) and the system MAC address (0000-fc00-6504 in
this sample output).
display link-aggregation load-sharing mode
Description
Use the display link-aggregation load-sharing mode command to display global or group-specific link-
aggregation load sharing criteria.
To display the global link-aggregation load sharing criteria, run the command without the interface
parameter.
To display all the group-specific load sharing criteria, run the command with the interface parameter, but
do not specify a particular interface.
To display the load sharing criterion or criteria of a particular aggregation group, perform the command
with the aggregate interface specified.
The bridge-aggregation parameter becomes available only after you create Layer 2 aggregate interfaces
on the device.
Syntax
display link-aggregation load-sharing mode [ interface [ bridge-aggregation interface-number ] ] [ | {
begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
To Next Page
Loading...
Need help?
General