HP A5830 Series Command Reference

207
By default, customer-side QinQ is disabled on Ethernet ports.
Enable or disable customer-side QinQ on one port in Ethernet interface view or on a group of ports in
port group view.
Syntax
qinq enable downlink
undo qinq enable
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level
Parameters
None
Examples
# Enable customer-side QinQ on port GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable downlink
# Enable customer-side QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet 1/0/6
[Sysname-port-group-manual-1] qinq enable downlink
qinq enable uplink
Description
Use the qinq enable uplink command to enable network-side QinQ on an Ethernet port.
Use the undo qinq enable command to disable network-side QinQ on the Ethernet port.
By default, network-side QinQ is disabled on Ethernet ports.
Enable or disable network-side QinQ on one port in Ethernet interface view or on a group of ports in port
group view.
Syntax
qinq enable uplink
undo qinq enable
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level

HP A5830 Series Specifications

General

Brand	HP
Model	A5830 Series
Category	Switch
Language	English