17
Use the undo duplex command to restore the default duplex mode of the Ethernet interface.
By default, Ethernet interfaces operate in auto-negotiation mode.
Related commands: speed.
Syntax
duplex { auto | full | half }
undo duplex
View
Ethernet interface view
Default level
2: System level
Parameters
auto: Sets the interface to operate in auto-negotiation mode.
full: Sets the interface to operate in full duplex mode.
half: Sets the interface to operate in half-duplex mode. This parameter is not available for Ethernet
copper ports that are configured with a 1000-mbps port speed and fiber ports.
Example
# Configure the interface GigabitEthernet 1/0/1 to operate in full-duplex mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] duplex full
flow-interval
Description
Use the flow-interval command to set the interface statistics polling interval.
Use the undo flow-interval command to restore the default interval.
In system view, use the flow-interval command to set the statistics polling interval for all interfaces.
In Ethernet interface view, use the flow-interval command to set the statistics polling interval for the
interface.
Syntax
flow-interval interval
undo flow-interval
View
Ethernet interface view
Default level
2: System level
To Next Page
Loading...
Need help?
General