HP A5830 Series

39
NOTE:
The Pair Impedance mismatch field has the following values:
Yes—Match
No—Mismatch
Layer 3 Ethernet interface configuration commands
mtu
Description
Use the mtu command to set the MTU for a Layer 3 Ethernet interface.
Use the undo mtu command to restore the default.
By default, the MTU of a Layer 3 Ethernet interface is 1500 bytes.
Syntax
mtu size
undo mtu
View
Layer 3 Ethernet interface view
Default level
2: System level
Parameter
size: Sets the MTU in bytes, whose range varies by interface types.
Example
# Set the MTU to 1430 bytes for the Layer 3 Ethernet interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mtu 1430