162
Syntax
port trunk permit vlan { vlan-id-list | all }
undo port trunk permit vlan { vlan-id-list | all }
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan-id-list: Specifies a list of VLANs that the trunk ports will be assigned to, in the format of [vlan-id1 [ to
vlan-id2 ] ]&<1-10>, where vlan-id is in the range of 1 to 4094 and &<1-10> indicates that you can
specify up to 10 VLAN IDs or VLAN ID ranges.
all: Permits all VLANs to pass through the trunk ports.
Examples
# Assign the trunk port GigabitEthernet 1/0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk permit vlan 2 4 50 to 100
Please wait........... Done.
# Assign the trunk Layer 2 aggregate interface Bridge-Aggregation 1 to VLAN 2.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type trunk
[Sysname-Bridge-Aggregation1] port trunk permit vlan 2
Please wait... Done.
Configuring GigabitEthernet1/0/1... Done.
Configuring GigabitEthernet1/0/2... Done.
Configuring GigabitEthernet1/0/3... Done.
The output shows that GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 are
the member ports of the aggregation group corresponding to Bridge-Aggregation 1.
port trunk pvid
Description
Use the port trunk pvid command to configure the PVID for the trunk port.
Use the undo port trunk pvid command to restore the default.
By default, the PVID of a trunk port is VLAN 1.
You can use a nonexistent VLAN as the PVID for a trunk port. If you use the undo vlan command to
remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
To Next Page
Loading...
Need help?
General