HP A5830 Series

182
isolate-user-vlan
Description
Use the isolate-user-vlan command to associate an isolate-user-VLAN with the specified secondary
VLANs.
Use the undo isolate-user-vlan command to remove the association.
By default, an isolate-user-VLAN is not associated with any secondary VLAN. .
The undo isolate-user-vlan command without the secondary secondary-vlan-id parameter specified
removes the association between the specified isolate-user-VLAN and all its secondary VLANs.
The undo isolate-user-vlan command with the secondary secondary-vlan-id parameter specified only
removes the association between the specified isolate-user-VLAN and the specified secondary VLANs.
Do not configure the default VLAN (VLAN 1) as a secondary VLAN or isolate-user-VLAN.
Related commands: display isolate-user-vlan.
Syntax
isolate-user-vlan isolate-user-vlan-id secondary secondary-vlan-id [ to secondary-vlan-id ]
undo isolate-user-vlan isolate-user-vlan-id [ secondary secondary-vlan-id [ to secondary-vlan-id ] ]
View
System view
Default level
2: System level
Parameters
isolate-user-vlan-id: Specifies an isolate-user-VLAN ID, in the range of 1 to 4094.
secondary secondary-vlan-id [ to secondary-vlan-id ]: Specifies a secondary VLAN ID or a secondary
VLAN ID range. The secondary-vlan-id parameter is a secondary VLAN ID, in the range of 1 to 4094.
Example
# Associate isolate-user-VLAN 2 with secondary VLANs VLAN 3 and VLAN 4.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] isolate-user-vlan enable
[Sysname-vlan2] port gigabitethernet 1/0/2
[Sysname-vlan2] vlan 3
[Sysname-vlan3] port gigabitethernet 1/0/3
[Sysname-vlan3] vlan 4
[Sysname-vlan4] port gigabitethernet 1/0/4
[Sysname-vlan4] quit
[Sysname] isolate-user-vlan 2 secondary 3 to 4