81
link-aggregation mode
Description
Use the link-aggregation mode dynamic command to configure an aggregation group to work in
dynamic aggregation mode.
Use the undo link-aggregation mode command to restore the default setting.
By default, an aggregation group works in static aggregation mode.
To change the aggregation mode of an aggregation group that contains member ports, remove all the
member ports from the aggregation group first.
Syntax
link-aggregation mode dynamic
undo link-aggregation mode
View
Layer 2 aggregate interface view
Default level
2: System level
Parameters
None
Example
# Configure the aggregation group corresponding to Bridge-Aggregation 1 to work in dynamic
aggregation mode.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
link-aggregation port-priority
Description
Use the link-aggregation port-priority command to set the aggregation priority of a port.
Use the undo link-aggregation port-priority command to restore the default setting.
The default aggregation priority of a port is 32,768.
Syntax
link-aggregation port-priority port-priority
undo link-aggregation port-priority
View
Ethernet interface view
Default level
2: System level
To Next Page
Loading...
Need help?
General