HP A5830 Series

63
By default, the description of an interface is interface-name Interface. For example, the default description
of Bridge-Aggregation1 is Bridge-Aggregation1 Interface.
Syntax
description text
undo description
View
Layer 2 aggregate interface view
Default level
2: System level
Parameter
text: Specifies the interface description, a string of 1 to 80 characters.
Example
# Set the description of Layer 2 aggregate interface Bridge-Aggregation 1 to connect to the lab.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] description connect to the lab
display interface
Description
Use the display interface command to display aggregate interface information.
If bridge-aggregation is not specified, this command displays information about all interfaces.
If bridge-aggregation is specified without any interface number specified, this command displays
information about all aggregate interfaces.
If bridge-aggregation interface-number is specified, this command displays information about the
specified aggregate interface.
Syntax
display interface bridge-aggregation [ brief [ down ] ] [ | { begin | exclude | include } regular-
expression ]
display interface bridge-aggregation interface-number [ brief ] [ | { begin | exclude | include } regular-
expression ]
View
Any view
Default level
1: Monitor level
Parameters
bridge-aggregation: Displays information about Layer 2 aggregate interfaces.