HP Aruba 3810M Series

1 Introducing the 3810M switches
The Aruba 3810M are multiport switches that can be used to build high-performance switched
networks. These switches are store-and-forward devices offering low latency for high-speed
networking. The 3810M switches also support a field-replaceable Redundant Power Supply and
fan tray, Power over Ethernet (PoE/PoE+) technologies, full network management capabilities
and a flexible uplink port slot.
In addition, the 3810M switches support the FlexChassis Mesh feature for stacking the switches.
When 3810M Stacking Modules (JL084A) are installed in the switches, any combination of up
to ten 3810M switches can be stacked together via high-speed backplane cables to form a single
extended virtual switch. See Stacking Information and Topologies, and the HPE ArubaOS-Switch
Advanced Traffic Management Guide K/KA/KB.16.01 for more stacking information.
These switches are described in this manual:
PoE+ SwitchesNon-PoE Switches
Aruba 3810M 24G PoE+ 1-slot Switch (JL073A)Aruba 3810M 24G 1-slot Switch (JL071A)
Aruba 3810M 48G PoE+ 1-slot Switch (JL074A)Aruba 3810M 48G 1-slot Switch (JL072A)
Aruba 3810M 40G 8 HPE Smart Rate PoE+ 1-slot Switch
(JL076A)
Aruba 3810M 16SFP+ 2-slot Switch (JL075A)
Accessories List
Flex port ModulePower SupplyStacking Module
Aruba 3810M 1QSFP+ 40GbE module
(JL078A)
Aruba X371 12VDC 250W 100-240VAC
Power Supply (JL085A)
Aruba 3810M 4-port Stacking
Module (JL084A)
Aruba 3810M 2QSFP+ 40GbE module
(JL079A)
Aruba X372 54VDC 680W 100-240VAC
Power Supply (JL086A)
Aruba 3810M 4SFP+ module (JL083A)Aruba X372 54VDC 1050W 110-240VAC
Power Supply (JL087A)
This chapter describes these switches with the following information:
• Front of the switches:
Network Ports◦
◦ Management Ports
◦ LEDs
◦ Buttons
◦ Flex Port Slot
◦ Module Support
• Back of the switches:
Power Supplies and Power Connectors◦
◦ Fan Tray
◦ Out-of-Band Management (OOBM)
• 3810M Stacking Module
• Switch Features
6 Introducing the 3810M switches