EasyManua.ls Logo

HP Aruba 3810M Series

HP Aruba 3810M Series
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Connectors” for pinouts and correct cable wiring. A category 5 or greater cable tester is a
recommended tool for every 100Base-TX and 1000Base-T network installation.
Check the port configuration. A port on your switch may not be operating as expected
because it is administratively disabled in the configuration. It may also be placed into a
“blocking” state by a protocol operating on the port (dynamic VLANs), or LACP (dynamic
trunking). For example, the normal operation of the Spanning Tree, GVRP, LACP, and other
features may put the port in a blocking state.
Use the switch console to determine the port’s configuration and verify that there is not an
improper or undesired configuration of any of the switch features that may be affecting the
port. For more information, see Management and Configuration Guide for your switch at
http://www.hpe.com/networking/support.
Diagnosing with the LEDs
Switch LED Error Indicators shows LED patterns on the switch that indicate switch problem
conditions.
Stacked Switch and Stacking Module LED Error Indicators shows LED patterns on the
switches and on stacking modules in a stack that indicate stack-related problem conditions.
1. Check in the tables for the LED pattern you see on your switch and stacking module.
2. Refer to the corresponding diagnostic tip on the next few pages.
Table 26 Switch LED Error Indicators
See
Diag
Tips
Back side of chassis
Port
LED
FP/IM
Mode/Status
Chassis
Status
Global
Status
LED
Stacking
Port
Stacking
Module
Fan
Status
PSUSpdPoEUsr
Back
LED
AUX
Port
1*********Off*Off
2*********Solid
Green
*Solid
Orange
3Slow
Flash
Orange**
Slow
Flash
Orange**
Solid
Green
Solid
Green
Slow
Flash
Orange**
Slow
Flash
Orange**
***Solid
Green
*Slow
Flash
Orange
4**Slow
Flash
Orange
******Slow
Flash
Orange
*Slow
Flash
Orange
5****Slow
Flash
Orange
****Solid
Green
*Slow
Flash
Orange
6Solid
Green
Solid
Green
Solid
Green
Solid
Green
Off****Solid
Green
*Solid
Green
7Solid
Green
Solid
Green
Solid
Green
Solid
Green
Half-Bright
Solid
Green
****Solid
Green
*Solid
Green
8**Solid
Green
Flashing
Green
*****Slow
Flash
Orange
*Slow
Flash
Orange
9**Solid
Green
Solid
Green
*****Solid
Green
*Slow
Flash
Orange
Diagnosing with the LEDs 69

Table of Contents

Related product manuals