4. Enter saupdate.efi get_mode 0:1:0:0 to verify the SAS mode is set to RAID.
After you replace the system board, you must port over the server serial number, product number
and UUID. Labels on the server indicates these numbers.
1. Log in to ILO 3 MP, by using SSH, for example.
2. Access the MP Main Menu.
3. Enter CM at the hpiLO-> prompt.
4. Enter sysset at the CM:hpiLO> prompt, and it will show the system information.
CM:hpiLO-> sysset
SYSSET
Current System Information Parameters:
Manufacturer : HP
Product Name (prodname) : Uninitialized
Secondary Product Name : Integrity rx2800 i2
Product Number (prodnum) : Uninitialized
Secondary Product Number : AH395A
Serial number (serial) : Uninitialized
Secondary Serial Number : USE1056FED
UUID (uuid) : FFFFFFFF-FFFF-FFFF-FFFF-FFFFFFFFFFFF
Secondary UUID : 371DABDA-491F-11E0-B2B9-7067579B3784
Product ID : 0x801
Primary and secondary system parameters values do not match.
Copy secondary parameters to primary? (Y/[N]):
5. Enter Y to the prompt to copy the serial number, product number, and UUID to the replacement
system board.
6. Reset iLO MP by entering xd -r -nc at the CM:hpiLO-> prompt.
Removing and replacing the system board 123
To Next Page
Loading...
Need help?
General
