EasyManuals Logo

HP Compaq d330 DT User Manual

HP Compaq d330 DT
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
Chapter 4 System Support
4.7
g to do with security, power management, temperature, and
verall status. These functions are handled by hardware and firmware (BIOS) and generally
configured through the Setup utility.
4.7.1
describes only the hardware functionality (including that supported by Setup) and
oes not describe security features that may be provided by the operating system and application
software.
4.7.1.1
OS) and if enabled
the password be cleared (preferable solution
(refer to section 4.6).
2. r Maintainance And
re that all system board LEDs are off (not illuminated).
ems) and move the
5. e AC power cord to the AC outlet and/or system unit.
. Turn on the system. The POST routine will clear and disable the password.
. To re-enable the password feature, repeat steps 1-6, replacing the jumper on pins 1 and 2 of
header E49.
4.7.1.2
he Setup utility may be configured to be always changeable or changeable only by entering a
password. The password is held on CMOS and, if forgotten, will require that CMOS be cleared
(refer to section 4.6).
SYSTEM MANAGEMENT
This section describes functions havin
o
SECURITY FUNCTIONS
These systems include various features that provide different levels of security. Note that this
subsection
d
Power-On Password
These systems include a power-on password, which may be enabled or disabled (cleared) through
a jumper on the system board. The jumper controls a GPIO input to the 82801 ICH5 that is
hecked during POST. The password is stored in configuration memory (CMc
and then forgotten by the user will require that either
nd described below) or the entire CMOS be cleared a
To clear the password, use the following procedure:
1. Turn off the system and disconnect the AC power cord from the outlet and/or system unit.
Remove the cover (hood) as described in the appropriate User Guide o
Service Guide. Insu
3. Locate the password clear jumper (header is labeled E49 on these syst
jumper from pins 1 and 2 and place on (just) pin 2 (for safekeeping).
4. Replace the cover.
Re-connect th
6
7
Setup Password
T
hp compaq d330 and d530 Series of Personal Computers
Featuring the Intel Pentium 4 Processor
First Edition – June 2003
4-24

Table of Contents

Other manuals for HP Compaq d330 DT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq d330 DT and is the answer not in the manual?

HP Compaq d330 DT Specifications

General IconGeneral
BrandHP
ModelCompaq d330 DT
CategoryDesktop
LanguageEnglish

Related product manuals