EasyManuals Logo

HP Compaq d330 DT User Manual

HP Compaq d330 DT
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background imageLoading...
Page #72 background image
Chapter 4 System Support
4.4.2 DIRECT MEMORY ACCESS
Direct Memory Access (DMA) is a method by which a device accesses system memory without
involving the microprocessor. Although the DMA method has been traditionally used to transfer
blocks of data to or from an ISA I/O device, PCI devices may also use DMA operation as well.
The DMA method reduces the amount of CPU interactions with memory, freeing the CPU for
other processing tasks.
NOTE: This section describes DMA in general. For detailed information regarding
DMA operation, refer to the data manual for the Intel 82801 I/O Controller Hub.
The 82801 ICH5 component includes the equivalent of two 8237 DMA controllers cascaded
together to provide eight DMA channels, each (excepting channel 4) configurable to a specific
device. Table 4-8 lists the default configuration of the DMA channels.
Table 4-8. Default DMA Channel Assignments
Table 4-8.
Default DMA Channel Assignments
DMA Channel Device ID
Controller 1 (byte transfers)
0
1
2
3
Spare
m Audio subsyste
Diskette drive
Parallel port
Con
4
troller 2 (word transfers)
5
6
7
Cascade for controller 1
Spare
Spare
Spare
All channels in DMA controller 1 operate at a higher priority than those in controller 2. Note that
channel 4 is not available for use other than its cascading function for controller 1. The DMA
controller 2 can transfer words only on an even address boundary. The DMA controller and page
register define a 24-bit address that allows data transfers within the address space of the CPU.
n addition to device configuration, each channI
R
el can be configured (through PCI Configuration
egi e of two modes of operation:
ode uses the LPC bus to communicate DMA channel control and is
plemented for devices using DMA through the LPC47B387 I/O controller such as the diskette
The PC/PCI DMA mode uses the REQ#/GNT# signals to communicate DMA channel control and
is used by PCI expansion devices.
sters) for on
LPC DMA
PC/PCI DMA
The LPC DMA m
im
drive controller.
hp compaq d330 and d530 Series of Personal Computers
Featuring the Intel Pentium 4 Processor
First Edition – June 2003
4-18

Table of Contents

Other manuals for HP Compaq d330 DT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq d330 DT and is the answer not in the manual?

HP Compaq d330 DT Specifications

General IconGeneral
BrandHP
ModelCompaq d330 DT
CategoryDesktop
LanguageEnglish

Related product manuals