HP DL360 - Page 154

154 HP ProLiant DL360 Generation 4 Server Reference and Troubleshooting Guide
Cache Has Been Disabled Because ADG Enabler Dongle is Broken or Missing......................162
Cache Has Been Disabled; Likely Caused By a Loose Pin on One of the RAM Chips.............162
Configuration Signature is Zero .................................................................................................162
Configuration Signature Mismatch ............................................................................................162
Controller Communication Failure Occurred.............................................................................163
Controller Detected. NVRAM Configuration not Present..........................................................163
Controller Firmware Needs Upgrading ......................................................................................163
Controller is Located in Special "Video" Slot............................................................................163
Controller Is Not Configured......................................................................................................164
Controller Reported POST Error. Error Code: X .......................................................................164
Controller Restarted with a Signature of Zero............................................................................164
Disable Command Issued ...........................................................................................................164
Drive (Bay) X Firmware Needs Upgrading................................................................................165
Drive (Bay) X has Insufficient Capacity for its Configuration ..................................................165
Drive (Bay) X has Invalid M&P Stamp .....................................................................................165
Drive (Bay) X Has Loose Cable.................................................................................................165
Drive (Bay) X is a Replacement Drive.......................................................................................166
Drive (Bay) X is a Replacement Drive Marked OK...................................................................166
Drive (Bay) X is Failed ..............................................................................................................166
Drive (Bay) X is Undergoing Drive Recovery...........................................................................166
Drive (Bay) X Needs Replacing.................................................................................................166
Drive (Bay) X Upload Code Not Readable ................................................................................167
Drive (Bay) X Was Inadvertently Replaced...............................................................................167
Drive Monitoring Features Are Unobtainable............................................................................167
Drive Monitoring is NOT Enabled for SCSI Port X Drive ID Y ...............................................167
Drive Time-Out Occurred on Physical Drive Bay X..................................................................168
Drive X Indicates Position Y......................................................................................................168
Duplicate Write Memory Error ..................................................................................................168
Error Occurred Reading RIS Copy from SCSI Port X Drive ID................................................168
FYI: Drive (Bay) X is Third-Party Supplied ..............................................................................168
Identify Logical Drive Data did not Match with NVRAM ........................................................169
Insufficient Adapter Resources ..................................................................................................169
Inter-Controller Link Connection Could Not Be Established ....................................................169
Less Than 75% Batteries at Sufficient Voltage..........................................................................169
Less Than 75% of Batteries at Sufficient Voltage Battery Pack X Below Reference Voltage ..170
Logical Drive X Failed Due to Cache Error...............................................................................170
Logical Drive X Status = Failed.................................................................................................170
Logical Drive X Status = Interim Recovery (Volume Functional, but not Fault Tolerant)........171
Logical Drive X Status = Loose Cable Detected........................................................................171
Logical Drive X Status = Overheated.........................................................................................171