HP DL360 - Page 155

Troubleshooting 155
Logical Drive X Status = Overheating .......................................................................................171
Logical Drive X Status = Recovering (rebuilding data on a replaced drive) .............................172
Logical Drive X Status = Wrong Drive Replaced......................................................................172
Loose Cable Detected - Logical Drives May Be Marked FAILED Until Corrected..................172
Mirror Data Miscompare............................................................................................................172
No Configuration for Array Accelerator Board..........................................................................173
NVRAM Configuration Present, Controller not Detected..........................................................173
One or More Drives is Unable to Support Redundant Controller Operation .............................173
Other Controller Indicates Different Hardware Model...............................................................173
Other Controller Indicates Different Firmware Version.............................................................173
Other Controller Indicates Different Cache Size........................................................................174
RIS Copies Between Drives Do Not Match ...............................................................................174
SCSI Port X Drive ID Y failed - REPLACE (failure message) .................................................174
SCSI Port X, Drive ID Y Firmware Needs Upgrading ..............................................................174
SCSI Port X, Drive ID Y Has Exceeded the Following Threshold(s)........................................175
SCSI Port X, Drive ID Y is not Stamped for Monitoring...........................................................175
SCSI Port X, Drive ID Y May Have a Loose Connection... ......................................................175
SCSI Port X, Drive ID Y RIS Copies Within This Drive Do Not Match ..................................176
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been Detected in the
Factory Monitor and Performance Data... ..................................................................................176
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been Detected in the
Power Monitor and Performance Data... ....................................................................................176
SCSI Port X, Drive ID Y Was Replaced On a Good Volume: (failure message) ......................176
Set Configuration Command Issued...........................................................................................177
Soft Firmware Upgrade Required...............................................................................................177
Storage Enclosure on SCSI Bus X has a Cabling Error (Bus Disabled)... .................................177
Storage Enclosure on SCSI Bus X Indicated a Door Alert.........................................................177
Storage Enclosure on SCSI Bus X Indicated a Power Supply Failure... ....................................177
Storage Enclosure on SCSI Bus X Indicated an Overheated Condition.....................................178
Storage Enclosure on SCSI Bus X is Unsupported with its Current Firmware Version... .........178
Storage Enclosure on SCSI Bus X Indicated that the Fan Failed...............................................178
Storage Enclosure on SCSI Bus X Indicated that the Fan is Degraded......................................179
Storage Enclosure on SCSI Bus X Indicated that the Fan Module is Unplugged... ...................179
Storage Enclosure on SCSI Bus X - Wide SCSI Transfer Failed...............................................179
Swapped Cables or Configuration Error Detected. A Configured Array of Drives... ................179
Swapped Cables or Configuration Error Detected. A Drive Rearrangement... ..........................180
Swapped Cables or Configuration Error Detected. An Unsupported Drive Arrangement Was
Attempted... ................................................................................................................................180
Swapped Cables or Configuration Error Detected. The Cables Appear To Be Interchanged....181
Swapped Cables or Configuration Error Detected. The Configuration Information on the