Page 3-24
‚Û Access the UNITS menu
L @)@FORCE Select units of force
@ @@N@@ Select Newtons (N)
` Enter quantity with units in the stack
The same quantity, entered in RPN mode uses the following keystrokes:
5 Enter number (no underscore)
‚Û Access the UNITS menu
L @)@FORCE Select units of force
@ @@N@@ Select Newtons (N)
Note: You can enter a quantity with units by typing the underline and units
with the ~keyboard, e.g., 5‚Ý~n will produce the entry: 5_N
Unit prefixes
You can enter prefixes for units according to the following table of prefixes
from the SI system.
The prefix abbreviation is shown first, followed by its name, and by the
exponent x in the factor 10
x
corresponding to each prefix:
___________________________________________________
Prefix Name x Prefix Name x
____________________________________________________
Y yotta +24 d deci -1
Z zetta +21 c centi -2
E exa +18 m milli -3
P peta +15 µ micro -6
T tera +12 n nano -9
G giga +9 p pico -12
M mega +6 f femto -15
k,K kilo +3 a atto -18
h,H hecto +2 z zepto -21
D(*) deka +1 y yocto -24
_____________________________________________________
(*) In the SI system, this prefix is da rather than D. Use D for deka in the
calculator, however.
To Next Page
Loading...
