Rack option kit Part number Description
Stabilizer kit
BW932A (600mm)
– or –
BW933A (800mm)
Anti-tip stabilizer kits provide stability and support
when equipment is installed, removed, or accessed
within the rack. Heavy-duty stabilizer kits should be
used when a single racked component exceeds
200lbs.
Stabilizer kit, heavy duty BW961A (600mm)
Anti-tip stabilizer kits provide stability and support
when equipment is installed, removed, or accessed
within the rack. Heavy-duty stabilizer kits should be
used when a single racked component exceeds
200lbs.
This kit is only available for 600mm wide racks.
Tie Down Kit Q9V01A
This kit is used to secure the rack to the data center
floor.
HPE Rack baying kit options
Not all baying kits fit with all racks. Use the image below to determine which baying kit to use based on how the racks are set
up in your data center.
Rack options 10
To Next Page
Loading...
Need help?
General
