HP G2 Series - Installing the cable management D-ring bracket in a side mount; Installing the cross-over bracket

Installing the cable management D-ring bracket in a side mount
Procedure
1.
Align the cable management D-ring bracket with the screw hole in the desired location on the side of your rack (1).
2.
Using a T-25 Torx driver, insert one M55 x10-mm Torx screw to secure the cable management D-ring bracket to the rack
(2).
Installing the cross-over bracket
Procedure
1. Align the cross-over bracket with the appropriate screw holes in the desired location across the back of the rack (1).
Cable Management Combo kit
24