HP G2 Series - Universal Rack Tie-down kit; Kit overview; Required tools; Installing the Universal Rack Tie-down kit

Universal Rack Tie-down kit
Kit overview
The Rack Tie-Down kit enables you to secure the racks to the floor.
Kit contents (Q9V01A)
Item Quantity
Front tie-down bracket 2
Rear tie-down bracket 1
M8 x 20-mm bolt 4
M8 x 22-mm bolt 4
M8 flat washer 8
M8 spring clip 4
Required tools
The following tools are required for installation:
• Ratchet with sockets
• Adjustable wrench
Installing the Universal Rack Tie-down kit
Procedure
1.
Adjust the leveling feet on the rack so that the full weight of the rack rests on the leveling feet.
2.
Align the front tie-down brackets with the holes on the front caster plate.
3.
Insert and partially tighten four bolts with washers, securing the front tie-down brackets to the front caster plate.
Universal Rack Tie-down kit
72