HP G2 Series - Fixed rail kit; Kit overview; Required tools; Installing the fixed rail kit

Fixed rail kit
Kit overview
This kit contains two - 4826cm (19 inches) to 7874cm (31 inches) - depth adjustable rails that mount rack-mountable
products in third-party racks. It also allows for most third-party rack-mountable products to be mounted in racks.
Kit contents (332558-B21)
Item Quantity
Rail, left 1
Rail, right 1
Rail, back 2
6M nut 4
M6 screw 10
Washer, M6 split 4
Washer, M6 flat 4
Cage nut 4
Additional hardware may be supplied for your convenience.
Required tools
The following tools are required for installation:
• Philips No. 1 screwdriver
• 10mm hex nut driver
Installing the fixed rail kit
Warning: To reduce the risk of personal injury or damage to the equipment, be sure that:
Procedure
1. Loosen the hex nuts, and extend the brackets to the desired length.
Fixed rail kit
31